The Accord’s serpentine belt is a single foremost drive belt operating the alternator, air conditioner compressor and presumably different equipment. Honda recommends checking this belt for put on each 7,500 miles or 6 months. Though some older type have parts that alter towards or away from the engine for belt stress, newer Honda Accord type have an auto-adjusting belt setup that makes changing the serpentine belt so much simpler.
Honda Accord Replace the Serpentine Belt Instructions
Discover the auto-adjusting belt tensioner. The belt tensioner pulley is situated typically situated behind the alternator and above the crankshaft on the Honda Accord.
Rotate the belt tensioner bolt to launch pressure on the belt. Rotation path could range by type, and a few type might have a distinct bolt head the place a breaker bar or ratchet could also be the extra relevant instrument. Verify proprietor’s documentation and use the acceptable measurement and magnificence of instrument to loosen the bolt.
Slip the outdated belt off of the pulleys, and use a routing belt diagram or sketch to put in the new serpentine belt. Honda usually features a belt routing diagram someplace underneath the hood, displaying the place the belt goes round numerous pulleys.
Rotate the tensioner once more to permit the belt to be put in on all pulleys, then slowly launch it to regain pressure. Run the engine and observe the belt for correct functioning. Earlier than beginning, be certain that the belt is seated correctly on all of the pulleys.
[taken from ehow.com]
